Cmc pt 35 manual

Fitting a PT to a small boat. Here’s our project, fit a trim and tilt system to a Quintrex fitted with a DT30 Suzuki Start by removing the engine from the transom, in this case a 1 inch block was spacing the outboard up, remove this at the same time. Use 2 “G” clamps to position the PT using the transom as a guide. Please read the Owner’s Manual completely before installing the PT The CMC PT has been predrilled on the transom side to mount to the boat. Be sure to use at least 1/2” diameter stainless steel bolts and nuts for mounting the PT to the boat. For proper installation the following items should be included in your PT box: 1. INSTALLATION Please read the Owners Manual completely before installing the PT The CMC PT has been predrilled on the transom side to mount to the boat. Be sure to use at least 1/2 diameter stainless steel bolts and nuts for mounting the PT to the boat. For proper installation the following items should be included in your PT box: 1.

Check here and let us know if you don't find what you're looking for! CMC CATALOG. CMC Marine - Brochure - Model Industrial Hydraulic Actuator. CMC Marine - Owner's Manual - PL Series - Power Lift Transom Jack. CMC Marine - Owner's Manual - Model PT Power Tilt and Trim. CMC Marine - Owner's Manual - Model PT Power Tilt and Trim. Fitting a PT to a small boat. Here’s our project, fit a trim and tilt system to a Quintrex fitted with a DT30 Suzuki Start by removing the engine from the transom, in this case a 1 inch block was spacing the outboard up, remove this at the same time. Use 2 “G” clamps to position the PT using the transom as a guide. Please read the Owner’s Manual completely before installing the PT The CMC PT has been predrilled on the transom side to mount to the boat. Be sure to use at least 1/2” diameter stainless steel bolts and nuts for mounting the PT to the boat. For proper installation the following items should be included in your PT box: 1.

I have the system installed as the instructions state. My cavitation plate sits about inches above the bottom of the boat. I now experience frequent. The current engine is a Mercury 35 without power tilt and trim. My motor and transom are both 20". The installation manual says to install. Thank you for choosing a CMC product. This manual is designed to aid in installation and maintenance of your PT Power Tilt and Trim. Each part of the CMC PT-.